Concrete Contractor in Cameron Park, TX - Driveways and Slabs Built on a Packed Base
Elite Brownsville Concrete Construction is a concrete contractor based in Brownsville that pours driveways, patios, sidewalks, steps and slabs for homes and small businesses in Cameron Park, with the ground dug out and packed first.
- Fully licensed and insured.
- Free estimates at your property.
- Replies within 1 business day.
Cameron Park lots and the concrete they need
Cameron Park is a colonia in southern Cameron County, about four miles north of downtown Brownsville, where we're based. Most of what we pour here is for single-family homes on their own lots, many of them lived in by the families who own them, and a lot of those houses have grown over the years with a room, a carport or a porch added on.
That shapes the work. Driveways here are often dirt, gravel or older concrete poured in pieces at different times, so many of our jobs start with breaking out what's there and fixing the ground under it.
Concrete work we do in Cameron Park
Concrete driveway building
Replaces a rutted dirt drive or a sunken old slab with a packed base and a slab that sheds water away from your house.
Concrete patio construction
A slab out back for grilling or gatherings, poured with a slight slope so water runs into the yard instead of sitting against your back door.
Stamped concrete services
Pressed with a pattern and colored to look like stone or tile, for a front walk or patio that sets your house apart without the upkeep of pavers.
Concrete sidewalk building
A firm path from the street or driveway to your door, so nobody tracks mud in, built with joints cut to keep cracks in straight lines.
Garage floor concrete
A new floor for a garage or carport, often one that started as dirt or a thin pour, thick enough to park on and sloped toward the door.
Decorative concrete
Color, exposed stone and saw-cut patterns for entries and patios, when you want more than plain gray but the slab still needs to drain and wear well.
Concrete retaining walls
Holds back soil where one part of the lot sits higher than another, so the yard stops washing onto the driveway or against the house.
Concrete floor installation
Interior slabs for shops, storage rooms and small businesses, poured level with a packed base so shelves and equipment sit flat and the floor sweeps clean.
Concrete pool decks
A deck around an above-ground or in-ground pool with a broom finish for grip, so wet feet don't slip, and a slope that sends splash water away.
Concrete steps construction
Replaces crumbling or uneven front and back steps with steps of even height, so nobody catches a toe going in or out of the house.
Slab foundation building
The slab under a new home or an addition, with the ground packed, forms set square and rebar, the steel that holds it together, placed before the pour.
Foundation installation
Footings and foundation work for houses, rooms added on and small buildings, laid out and checked before the truck shows up so the walls start level.
Concrete parking lot building
Paved parking for shops, churches and small businesses, graded so water drains off instead of pooling where customers walk in.
Concrete footings
Footings for carports, patio covers, porches and block walls, dug to firm ground so the posts and walls on top have something solid to sit on.
Foundation raising
When a slab or part of a house has dropped and doors stick or cracks open up, we look at why it moved before talking about lifting it.
Concrete cutting
Clean saw cuts to take out a cracked section, open a slab for a plumbing line or widen a driveway, without breaking up what you're keeping.
Get a free on-site concrete estimate in Cameron Park
Send the form or call, and we'll get back to you within one business day to set up a visit. I come out myself, write up a free estimate with the scope in writing, and there's no pressure to book.
(956) 505-5331- Based in
- Brownsville, TX 78520
- Hours
- Mon–Sun: 7 AM–10 PM
Permits, prices and timing for Cameron Park jobs
Before we start in Cameron Park, I check which office covers your address, because the county's Building Permits Division handles permits, inspections and site review for development in the unincorporated parts of Cameron County. Its permit list names mechanical, plumbing and electrical work, so for a slab I ask the office about your job instead of guessing, then help with the permit steps for our part and put any inspections on the calendar with you. The county takes applications through an online portal, so you can track the permit and its inspections there yourself. What moves your price is the slab's size and thickness, how much digging and base work the ground needs and whether old concrete has to come out first. The schedule turns on any county review and the days the concrete needs to cure, and your written estimate puts your own number on it.
FM 1847 is the main way in, and we plan truck access before pour day, because a mixer needs a clear path to the forms and some lots here are tight between houses, fences and parked cars. We do the same work in Los Fresnos and San Benito, and I've run this business since 2017. We're fully licensed and insured, our own crew does the work with an experienced lead running each pour, and every job is backed by our satisfaction guarantee.
Water and loose ground under Cameron Park slabs
The county's own flood rules say its flood hazard areas flood from time to time, and when water sits around a slab it soaks the ground underneath, which is how a driveway or patio starts to sink and tip. So before we set a form, I look at where water runs off your lot, and we slope the slab away from the house and toward somewhere the water can go.
Many of the cracked, sunken slabs we tear out here were poured on dirt that was raked flat, not dug out and packed, so they settled as the dirt did. The subgrade, the packed ground a slab sits on, is hidden on day one and the first thing people want to cut, and it's the last place I'd save money, because a nice finish on a bad base cracks just the same.
How a concrete job runs in Cameron Park
Here's how it goes from your first call to walking the finished slab, and who you'll deal with at each step.
Call us or send the form
Tell us what you want poured and roughly where on the lot. We call back to set a time for me to come out at an hour that works for you.
Walk the site with me
I check the ground, where water runs, where any septic tank and lines sit and how a truck gets in, and I ask how you'll use the slab. You get a written estimate that spells out what's in and what isn't, so you know exactly what you're paying for.
We prep and pour it
Once you say go, we line up the permit steps with the county, dig out and pack the base, set the forms and pour when conditions suit it, with our lead running the pour. Soon after, we cut control joints, shallow lines that give the slab a planned place to crack.
Walk the finished work together
We walk the slab with you, go over anything you want looked at and clean up. I'll tell you how long to keep feet and cars off it, because concrete gains strength as it cures and a load too early can mark or crack it.
Questions about concrete work in Cameron Park
How much does a concrete driveway cost in Cameron Park, TX?
The cost of a driveway here comes from its size, its thickness, how much ground prep it needs, whether an old slab comes out first and the finish you choose. A car driveway is usually about 4 inches thick, and one that carries trucks goes thicker and costs more, while a plain broom finish costs less than stamped or colored work. I give you a written number after I see the lot.
How do I know if I need a floodplain permit for concrete work in Cameron Park?
You find out by checking whether your lot sits in a special flood hazard area on the flood map, because FEMA says a permit is required before construction or development begins in one. Cameron County's flood rules exist so its unincorporated areas qualify for flood insurance, so I check your address with the county before we plan the job.
Does a new slab for an addition or patio cover in Cameron County need a windstorm certificate?
If you want windstorm insurance through TWIA, new structures, additions and patio covers are among the work it says has to be certified, and Cameron County is covered by the state's windstorm inspection program. That certificate is an insurance matter separate from any county permit, so sort it out with whoever builds the structure before we pour the slab under it.
Can you pour a driveway or patio near my septic system in Cameron Park?
Yes, we find the tank and lines first and plan the slab around them, keeping it off any lid you'll need to reach. Building, altering, extending or repairing a septic system takes a permit under state rules, handled here by the county's septic program, so if a job would change any part of the system we settle that before we dig.
How long does a new concrete driveway take before I can drive on it?
You can usually walk on new concrete after a day or two and drive a car on it after about a week, and it keeps gaining strength for weeks after that. Heavy trucks should wait longer, and I'll give you the timing for your slab when we walk the finished work.
What causes concrete driveways in Cameron Park to crack and sink?
Concrete cracks because it shrinks as it cures and moves when the ground under it moves, and sinking almost always traces back to a base that wasn't packed. Some cracking is normal and I won't promise a slab that never cracks, but joints cut on time, rebar where the load calls for it and water sent away from the slab keep cracks where we planned them.
Brownsville, TX
Plan your Cameron Park concrete job today
One visit tells you what your ground needs before any money goes into concrete, so you can plan the job around a real number.